Maintenance method of chuck

Power chuck to maintenance and maintenance in the use process, the following maintenance method for concrete:
(1) must play a molybdenum disulfide grease every day, is the oil into the oil inside the power chuck, the best hit oil spill degree. There are some power chuck is to compare high speed rotation or is in the processing time is to use water-based cutting fluid is very much, then suggest to use more oil, it is best to operate according to different conditions.
(2) according to the different work piece, must use different clamping force or making special fixture, reluctant to use it to clamp the irregular or strange artifacts, will cause the power chuck, chuck damaged, if the pressure is not normal, will make the chuck at high pressure, or machine workpiece clamping chuck will also, this will reduce the chuck life, so when you find chuck gap is too large, the replacement of the new cartridge immediately must.
(3) can guarantee the above power chuck lathe using a long time, this is very important, and to maintain relatively good accuracy is very important, so we need attention lubrication of the power chuck work. If you use the incorrect or inappropriate then lubrication problems easier, for example in the low pressure time, will not be able to work normally, so be sure to correct lubrication power chuck.
(4) at least once every 6 months to remove the chuck jaws decomposition cleaning, keep clean and lubricated sliding surface, so that the chuck life growth, but if cutting cast iron every 2 months at least once or several times to clean it thoroughly, check the parts without fracture and wear of the situation, serious person immediately replaced with a new one, after the examination, should give oil, to group.