Hydraulic chuck installation notes

1, when changing a joint part, tooth type and T type nut must clean up the basic jaws, otherwise it will cause the accuracy of No.
2, in accordance with the shape of workpiece and cutting conditions to set the hydraulic pressure, if the tubular workpiece by high voltage clamp will cause deformation.
3, clamp casting workpiece holding surface or conical, special claw used with dentate clamping surface of workpiece material, not flying.
4, the clamping eccentric workpiece material, the effects of centrifugal force eccentric weight in a single claw, processing to use low speed.
5, can not be used with the base claw rows of teeth is not above claw, denticity is insufficient, will affect the clamping force and precision, serious damage to the base jaw.
Before 6, the operation began, the use of low speed at once, check the position of the object and a workpiece and tool, the tool seat interference.
7, if the length of the workpiece clamping, the use of the tailstock center supports the other end or.
8, long time holding machine, chuck can not clamp the work.
9, when the improper operation or mechanical failure caused by tool or cutter base hit chuck, immediately stop check up, base claw, T block, connecting screws and accuracy of clamping is normal.
Hydraulic pressure 10, special use highly a need than the standard lower low.